سعر المايكروسمنت في الكويت: شنو يحدد عرض السعر؟

الكاتب: مايكروسمنت الكويت

Planning microcement for your bathroom, kitchen, walls or floors in Kuwait? Almusaileem supplies and installs. We review your site details before defining the work and quotation.

Assessment requestArea calculatorInspection checklistPhoto guideCompare quotationsProject sheet

These tools work on this page. They do not save your entries, upload photographs or send anything automatically. Copy anything you need before refreshing or leaving. Only the request you review and choose to open is passed to WhatsApp.

Prepare your project assessment request

Enter what you know, then review and edit the message before opening WhatsApp. Attach your site photographs in WhatsApp. Fields marked * are required.

Required service *Choose a serviceMicrocementEpoxy flooringPaintingFlat stone, wood or marble alternativesHidden doorsHelp choosing a finish Area in Kuwait * Property and project details

Calculate approximate floor and wall area

For a rectangular room, using internal dimensions in metres. This calculates area, not a price or material quantities.

What would you like to calculate?Floor and wallsFloor only

Accepts 123, ١٢٣ and ۱۲۳, with . or ٫ as the decimal mark. Do not enter thousands separators or measurement units in the fields.

Room length in metres *

Room width in metres *

Wall and opening measurements

Wall height in metres * Known door and window openings in square metres

The total opening area to deduct. A blank field counts as zero.

Add identical openings by dimensions (optional)

This area is added to the known openings above. Do not count the same opening twice.

Opening width in metres

Opening height in metres

Number of identical openings

Floor: —

Walls before openings: —

Walls after openings: —

Floor = length × width. Walls = 2 × (length + width) × height minus openings. These estimates exclude waste. Irregular shapes, steps and slopes require separate measurements. Confirm dimensions on site; the area included in a quotation may differ.

Prepare for a site inspection

Use this checklist to organise information. It is not a technical inspection or confirmation that a surface is suitable.

Information prepared

I recorded the length, width and height and identified the required floors and walls. I identified doors, windows and areas excluded from the work. I prepared clear wide photographs of each space from more than one angle. I prepared close-ups of corners, edges, joints, drains and visible concerns. I prepared a colour and finish reference to discuss using a physical sample in the room’s lighting. I noted access, furniture to move and a suitable inspection time.

Observations needing a qualified assessment

Visible or previous moisture or leaks Cracks or joints needing review Tiles that move or seem unstable A wet area: bathroom, shower or around a drain

Tick only what you have noticed or know about. An unticked box does not mean there is no problem.

Record furniture, appliances, access and protection needs, and discuss a physical colour sample. Use accessible positions for photographs; do not remove tiles or fittings.

Checklist summary

Which photographs should I send?

Usually six to eight clear photographs per space are useful. Choose the views that apply; you do not need to reach a fixed number. Use the normal camera without filters or digital zoom.

Stay on stable, dry ground. Do not climb a ladder or chair, approach exposed wiring or move onto a wet surface. Skip an unsafe view and describe it instead.

1. From the doorway: show the floor, walls and limits of the space in a wide view.
2. From the opposite side: show the parts missing from the first photograph, openings and fixed furniture from another accessible angle.
3. Floor close-up: show the existing surface and joints. Do not scrape, tap or remove material.
4. Wall, corner and edge: if walls are included, show the surface and an accessible junction with the floor or a corner.
5. Door and threshold: show the bottom of the door and the transition to the next room. A photograph does not establish final clearance or floor level.
6. Drain and work boundaries, if relevant: photograph from a dry position. Do not run water, lift drain covers or dismantle fittings.
7. Visible damage, if present: take a wide view locating cracks, peeling or moisture marks, then a close-up. Mention known leaks or loose tiles without testing or pressing them.
8. Measurement, if safe: show a ruler or tape reading and its unit at an accessible low point. Do not climb to measure height or extend a tape near electricity. Write “unknown” if you do not know a measurement.

Keep people, children, documents, addresses, number plates and personal belongings out of view. Check mirrors and glass for reflections and crop private details before sending. The area name is enough for an initial inquiry.

An optional slow 10–15-second video can clarify the layout while you stand safely. Review its audio and reflections before sharing. Photographs alone are enough to start an inquiry.

Group photographs by room, add short captions where needed and distinguish current-site photographs from design or colour references. Add the surfaces required and approximate measurements, and mark uncertain details clearly.

Photographs provide initial information. They do not diagnose moisture or cracks, verify surface stability or waterproofing, or replace an on-site inspection when needed. They are not a quotation, warranty or approval to install.

This page does not open your camera, request your location or upload photographs. Choose and attach photographs yourself inside WhatsApp after reviewing them.

Prepare your assessment request · Review the inspection checklist

Compare two or three quotations

Enter the terms from quotations you already have. Compare the same scope, preparation, system, finish, exclusions, schedule and permitted use. Ask for care instructions and any written warranty scope. This tool does not calculate prices, rank providers or choose a winner.

Number of quotationsTwo quotationsThree quotations

A blank field means “not recorded here”, not included or excluded. Ask the provider to clarify missing terms. Do not compare only the final total.

Quotation 1

Provider / quotation referenceWork scope and areaSurface preparation and repairsWaterproofing and wet-area detailsSystem, protective layer and finishColour and approved sampleExclusionsWarranty as writtenDuration and return-to-use timingPayment stages and conditionsQuoted total and currency (optional)

Quotation 2

Provider / quotation referenceWork scope and areaSurface preparation and repairsWaterproofing and wet-area detailsSystem, protective layer and finishColour and approved sampleExclusionsWarranty as writtenDuration and return-to-use timingPayment stages and conditionsQuoted total and currency (optional)

Recorded quotation summary

Keep a printable project sheet

Organise measurements, sample references and notes. Fill in what you need or print a blank sheet. Keep copies of the approved sample, colour code, system name, quotation, agreed dates, photographs and care instructions.

Finishing project record

Almusaileem · Kuwait · 56510526

Project reference / short name

Date of notes

Area and property type

Work scope

Measurements, openings and areas

Surface condition and points to review

Sample, colour and finish reference

Preparation, waterproofing and system to review

Timing and return to use

Handover and follow-up notes

A personal organisation sheet, not a quotation, appointment confirmation, contract or acceptance of completed work. Review details, measurements and observations with the appropriate specialist. This sheet has no signature or approval field.

What happens next?

We review the details and explain whether more photographs or an on-site inspection is needed. Price and schedule depend on the surface, area and required work. Agree the preparation, exclusions, return-to-use timing and care instructions before installation.

Working hours (Kuwait, UTC+3): Saturday–Thursday, 09:00–21:00; Friday, 16:00–21:00. For complete project information received outside these hours, the assessment window starts at the next opening.

Send project photos on WhatsApp

For inquiries: 56510526

تقييم مشروعك خلال ساعة واحدة

في المسيليم للأصباغ والديكور، بعد استلام صور الموقع والمقاسات والمنطقة وتفاصيل العمل كاملة، نرد عليك بالتقييم الأولي خلال ساعة واحدة من أوقات العمل.

وإذا احتاج المشروع معاينة ميدانية، ننسق معاك الموعد المناسب.

ساعات العمل بتوقيت الكويت: السبت إلى الخميس من 9 صباحاً إلى 9 مساءً؛ الجمعة من 4 عصراً إلى 9 مساءً. الطلب المكتمل خارج هذه الأوقات يبدأ احتساب الرد عليه مع بداية فترة العمل التالية.

للاستفسار: 56510526

تعديل الصفحة